First, with a hammer drilling, install the plastic expansion bolt, hand breaking the cover, with wood screws to the bottom plate into the expansion bolt, no hammer or impact drill time, you can directly use the cement nail the bottom plate Wall, turn and sub-line where you can use the angle, the corners, three links.
Second, the power and the socket at the end of the line after the wire put the bottom plate, buckle the cover, the discharge line and buckle at the same time, the floor of the interface and cover the interface to be staggered. Pole line when the zero line without switching, direct connection lamp and power; FireWire must be into the switch, switch to stay enough thread.
Third, the trunking is not long enough to continue when the need to intercept the trunking, tools can be used utility knife, you can also use the diagonal pliers, floor and cover at the same time can be intercepted with hacksaw.
With a jacket line wiring, can be laid directly in the hollow floor and the wall, first with pencil and carpenter with ink fountain line positioning, with steel fine head or plastic line card fixed, line card spacing 20cm, must be horizontal Straight flat service, wiring as far as possible to tighten.
Copyright ? 2010 - 2025 zmscable.com All Rights Reserved.
